orinoco_cs on StrongArm board

[Jacky Li]

I've been trying to get my orinoco card working on a StrongArm board but
fails.  The card seems to be successfully recognized by PCMCIA services
but it doesn't get through when the cardmgr was trying to execute
'./network start eth0'.  It has timeout error message shown as below in
/var/log/messages.
=========================================================
[root at Linux /root]$tail /var/log/messages
<7>eth0: MAC address 00:02:2D:0F:0A:61
<7>eth0: Station name "HERMES I"
<7>eth0: ready

Jan  1 00:00:14 Linux daemon.info cardmgr[124]: executing: './network
start eth0'
Jan  1 00:00:14 Linux kern.debug eth0: index 0x01: Vcc 3.3, irq 45, io
0xf6000000-0xf600003f

Jan  1 00:00:22 Linux kern.info NETDEV WATCHDOG: eth0: transmit timed
out
<4>eth0: Tx timeout! Resetting card.
=========================================================
[root at Linux /root]$iwconfig eth0
eth0      IEEE 802.11-DS  ESSID:"ATTLABS"  Nickname:"Linux"
          Frequency:2.427GHz  Sensitivity:1/3  Mode:Managed
          Access Point: 00:02:2D:05:80:8B
          Bit Rate:2Mb/s   RTS thr:off   Fragment thr:off
          Power Management:off
          Link quality:35/92  Signal level:-55 dBm  Noise level:-90 dBm
          Rx invalid nwid:0  invalid crypt:0  invalid misc:0

The essid and access point MAC address are correctly detected.  Anyone
knows why it has timeout message?
Anyone is familar with porting an orinoco driver to StrongArm system?
Please give me some advices or direct me to useful resources about that.

Thanks a lot!

Regards,
Jacky