[Samba] Update
Rowland Penny
rowlandpenny at googlemail.com
Mon Mar 2 09:01:36 MST 2015
On 02/03/15 15:05, sandy.napoles at eccmg.cupet.cu wrote:
> ifconfig -a
> eth0 Link encap:Ethernet HWaddr 00:0c:29:82:ec:80
> inet addr:172.18.68.8 Bcast:172.18.68.31 Mask:255.255.255.224
> inet6 addr: fe80::20c:29ff:fe82:ec80/64 Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:107940 errors:0 dropped:0 overruns:0 frame:0
> TX packets:109315 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:14394078 (13.7 MiB) TX bytes:20253880 (19.3 MiB)
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> inet6 addr: ::1/128 Scope:Host
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:252 errors:0 dropped:0 overruns:0 frame:0
> TX packets:252 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:38555 (37.6 KiB) TX bytes:38555 (37.6 KiB)
>
>
> ip -f inet6 route
> fe80::/64 dev eth0 proto kernel metric 256
>
>
>
>> Thanks. No other interfaces (ifconfig -a)?
>>
>> Also output of
>>
>> ip -f inet6 route
>>
>> would be useful.
>>
>> David
>> ------------------------------------------------------------------------
>> Dr David Holder CEng FIET MIEEE
>>
>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>
>> Reception: +44 (0)1422 207000
>>
>> Direct Dial: +44 (0)131 2026317
>>
>> http://www.erion.co.uk
>>
>>
>> Registered in England and Wales. Registered Number 3521142
>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>> Durham, DL3 7EH, UK
>> VAT Number: GB 698 3633 78
>>
>> On 02/03/2015 14:26, sandy.napoles at eccmg.cupet.cu wrote:
>>> in /etc/gai.conf all is coment
>>>
>>>> Hi Sandy,
>>>>
>>>> Thanks! Curious. Do you have any other interfaces? ifconfig -a should
>>>> show them all including loopback.
>>>>
>>>> What is puzzling me is that it should not even attempt to use IPv6 to
>>>> reach a global address when it only has a link-local address. It should
>>>> gracefully fall back to IPv4 (as per RFC 6724 or RFC 3484 depending on
>>>> the kernel version). Since you have an IPv4 address and I assume an
>>>> IPv4
>>>> connection, then this should work over IPv4.
>>>>
>>>> I'm assume that you do not have an /etc/gai.conf file installed?
>>>>
>>>> David
>>>> ------------------------------------------------------------------------
>>>> Dr David Holder CEng FIET MIEEE
>>>>
>>>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>>>
>>>> Reception: +44 (0)1422 207000
>>>>
>>>> Direct Dial: +44 (0)131 2026317
>>>>
>>>> http://www.erion.co.uk
>>>>
>>>>
>>>> Registered in England and Wales. Registered Number 3521142
>>>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>>>> Durham, DL3 7EH, UK
>>>> VAT Number: GB 698 3633 78
>>>>
>>>> On 02/03/2015 13:10, sandy.napoles at eccmg.cupet.cu wrote:
>>>>> eth0 Link encap:Ethernet HWaddr d0:27:88:64:e4:01
>>>>> inet addr:172.18.70.100 Mask:255.255.255.224
>>>>> inet6 addr: fe80::d227:88ff:fe64:e401/64 Scope:Link
>>>>> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
>>>>> RX packets:1413908 errors:0 dropped:0 overruns:0 frame:0
>>>>> TX packets:447039 errors:0 dropped:0 overruns:0 carrier:0
>>>>> collisions:0 txqueuelen:1000
>>>>> RX bytes:1693689457 (1.5 GiB) TX bytes:52974612 (50.5
>>>>> MiB)
>>>>> Interrupt:43 Base address:0xc000
>>>>>
>>>>>
>>>>> traceroute6 git.samba.org
>>>>> traceroute to git.samba.org (2001:638:603:d06e::80:230), 30 hops max,
>>>>> 80
>>>>> byte packets
>>>>> connect: Network is unreachable
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>> Hi Sandy,
>>>>>>
>>>>>> Please can you provide the output from an *i**fconfig -a* command?
>>>>>>
>>>>>> This should give an idea of what is going on. Turning off IPv6 will
>>>>>> not
>>>>>> be necessary if you can find the actual cause of the problem.
>>>>>>
>>>>>> You would not get this error message if you only have a link local
>>>>>> address configured on your interface. You must have some form of
>>>>>> global
>>>>>> address.
>>>>>>
>>>>>> Also, the IPv6 address is that of git.samba.org not samba.org. You
>>>>>> could
>>>>>> try:
>>>>>>
>>>>>> *traceroute6 git.samba.org.*
>>>>>>
>>>>>> Best Regards,
>>>>>> David
>>>>>> ------------------------------------------------------------------------
>>>>>> Dr David Holder CEng FIET MIEEE
>>>>>>
>>>>>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>>>>>
>>>>>> Reception: +44 (0)1422 207000
>>>>>>
>>>>>> Direct Dial: +44 (0)131 2026317
>>>>>>
>>>>>> http://www.erion.co.uk
>>>>>>
>>>>>>
>>>>>> Registered in England and Wales. Registered Number 3521142
>>>>>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>>>>>> Durham, DL3 7EH, UK
>>>>>> VAT Number: GB 698 3633 78
>>>>>>
>>>>>> On 28/02/2015 18:38, Reindl Harald wrote:
>>>>>>> Am 28.02.2015 um 19:13 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>>>> I do not working with ipv6, I have disable, but I have the same
>>>>>>>> error,
>>>>>>>> I
>>>>>>>> can read in internet that this ipv6 ip 2001:638:603:d06e::80:230:
>>>>>>>> belong
>>>>>>>> to url samba.org....
>>>>>>>>
>>>>>>>> If I try to connect to this url using some navegator I connected
>>>>>>>> perfect....but when I run git pull using command line I can not
>>>>>>>> connect..
>>>>>>> the question is *how* did you disable ipv6 - when ifconfig shows a
>>>>>>> "link local" ipv6 address the stack is *not* entirely disabled
>>>>>>>
>>>>>>> [root at srv-rhsoft:~]$ ifconfig eth0
>>>>>>> eth0: flags=4419<UP,BROADCAST,RUNNING,PROMISC,MULTICAST> mtu 1500
>>>>>>> ether 24:be:05:1a:c0:27 txqueuelen 100 (Ethernet)
>>>>>>> RX packets 2460 bytes 577531 (563.9 KiB)
>>>>>>> RX errors 0 dropped 0 overruns 0 frame 0
>>>>>>> TX packets 8722 bytes 1981928 (1.8 MiB)
>>>>>>> TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
>>>>>>> device interrupt 20 memory 0xf7e00000-f7e20000
>>>>>>>
>>>>>>>>> Am 28.02.2015 um 15:37 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>>>>>> Hello list, Iam using samba4 as Domain Controller my verion
>>>>>>>>>> Version
>>>>>>>>>> 4.3.0pre1-GIT-068f9e2, but I have a little problem when I going
>>>>>>>>>> to
>>>>>>>>>> update
>>>>>>>>>> using GIT PULL I have this error
>>>>>>>>>>
>>>>>>>>>> error: Failed to connect to 2001:638:603:d06e::80:230: Network is
>>>>>>>>>> unreachable while accessing
>>>>>>>>>> http://git.samba.org/samba.git/info/refs
>>>>>>>>>> fatal: HTTP request failed
>>>>>>>>>>
>>>>>>>>>> some body can helpme
>>>>>>>>> do you have working ipv6?
>>>>>>>>> if not disable it via sysctl.conf
>>>>>>>>>
>>>>>>>>> net.ipv6.conf.all.disable_ipv6=1
>>>>>>>>> net.ipv6.conf.default.disable_ipv6=1
>>>>>>>>>
>>>>>>>>> that above is most likely because the link-local address if the
>>>>>>>>> ipv6
>>>>>>>>> stack is enabled and some piece of software thinks it's useable
>>>>>>>>>
>>>>>>>>> --
>>>>>>>>> To unsubscribe from this list go to the following URL and read the
>>>>>>>>> instructions: https://lists.samba.org/mailman/options/samba
>>>>>> --
>>>>>> To unsubscribe from this list go to the following URL and read the
>>>>>> instructions: https://lists.samba.org/mailman/options/samba
>>>>>>
>>>> --
>>>> To unsubscribe from this list go to the following URL and read the
>>>> instructions: https://lists.samba.org/mailman/options/samba
>>>>
>> --
>> To unsubscribe from this list go to the following URL and read the
>> instructions: https://lists.samba.org/mailman/options/samba
>>
>
OK, nobody seems to have asked this yet, what OS and how are you trying
to update git, just what are you typing into the terminal ?
Rowland
More information about the samba
mailing list