[Samba] Update

sandy.napoles at eccmg.cupet.cu sandy.napoles at eccmg.cupet.cu
Mon Mar 2 08:05:14 MST 2015 

ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:0c:29:82:ec:80
          inet addr:172.18.68.8  Bcast:172.18.68.31  Mask:255.255.255.224
          inet6 addr: fe80::20c:29ff:fe82:ec80/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:107940 errors:0 dropped:0 overruns:0 frame:0
          TX packets:109315 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:14394078 (13.7 MiB)  TX bytes:20253880 (19.3 MiB)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:252 errors:0 dropped:0 overruns:0 frame:0
          TX packets:252 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:38555 (37.6 KiB)  TX bytes:38555 (37.6 KiB)


ip -f inet6 route
fe80::/64 dev eth0  proto kernel  metric 256



> Thanks. No other interfaces (ifconfig -a)?
>
> Also output of
>
> ip -f inet6 route
>
> would be useful.
>
> David
> ------------------------------------------------------------------------
> Dr David Holder CEng FIET MIEEE
>
> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>
> Reception: +44 (0)1422 207000
>
> Direct Dial: +44 (0)131 2026317
>
> http://www.erion.co.uk
>
>
> Registered in England and Wales. Registered Number 3521142
> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
> Durham, DL3 7EH, UK
> VAT Number: GB 698 3633 78
>
> On 02/03/2015 14:26, sandy.napoles at eccmg.cupet.cu wrote:
>> in  /etc/gai.conf all is coment
>>
>>> Hi Sandy,
>>>
>>> Thanks! Curious. Do you have any other interfaces? ifconfig -a should
>>> show them all including loopback.
>>>
>>> What is puzzling me is that it should not even attempt to use IPv6 to
>>> reach a global address when it only has a link-local address. It should
>>> gracefully fall back to IPv4 (as per RFC 6724 or RFC 3484 depending on
>>> the kernel version). Since you have an IPv4 address and I assume an
>>> IPv4
>>> connection, then this should work over IPv4.
>>>
>>> I'm assume that you do not have an /etc/gai.conf file installed?
>>>
>>> David
>>> ------------------------------------------------------------------------
>>> Dr David Holder CEng FIET MIEEE
>>>
>>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>>
>>> Reception: +44 (0)1422 207000
>>>
>>> Direct Dial: +44 (0)131 2026317
>>>
>>> http://www.erion.co.uk
>>>
>>>
>>> Registered in England and Wales. Registered Number 3521142
>>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>>> Durham, DL3 7EH, UK
>>> VAT Number: GB 698 3633 78
>>>
>>> On 02/03/2015 13:10, sandy.napoles at eccmg.cupet.cu wrote:
>>>> eth0      Link encap:Ethernet  HWaddr d0:27:88:64:e4:01
>>>>             inet addr:172.18.70.100  Mask:255.255.255.224
>>>>             inet6 addr: fe80::d227:88ff:fe64:e401/64 Scope:Link
>>>>             UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>>>>             RX packets:1413908 errors:0 dropped:0 overruns:0 frame:0
>>>>             TX packets:447039 errors:0 dropped:0 overruns:0 carrier:0
>>>>             collisions:0 txqueuelen:1000
>>>>             RX bytes:1693689457 (1.5 GiB)  TX bytes:52974612 (50.5
>>>> MiB)
>>>>             Interrupt:43 Base address:0xc000
>>>>
>>>>
>>>> traceroute6 git.samba.org
>>>> traceroute to git.samba.org (2001:638:603:d06e::80:230), 30 hops max,
>>>> 80
>>>> byte packets
>>>> connect: Network is unreachable
>>>>
>>>>
>>>>
>>>>
>>>>> Hi Sandy,
>>>>>
>>>>> Please can you provide the output from an *i**fconfig -a* command?
>>>>>
>>>>> This should give an idea of what is going on. Turning off IPv6 will
>>>>> not
>>>>> be necessary if you can find the actual cause of the problem.
>>>>>
>>>>> You would not get this error message if you only have a link local
>>>>> address configured on your interface. You must have some form of
>>>>> global
>>>>> address.
>>>>>
>>>>> Also, the IPv6 address is that of git.samba.org not samba.org. You
>>>>> could
>>>>> try:
>>>>>
>>>>> *traceroute6 git.samba.org.*
>>>>>
>>>>> Best Regards,
>>>>> David
>>>>> ------------------------------------------------------------------------
>>>>> Dr David Holder CEng FIET MIEEE
>>>>>
>>>>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>>>>
>>>>> Reception: +44 (0)1422 207000
>>>>>
>>>>> Direct Dial: +44 (0)131 2026317
>>>>>
>>>>> http://www.erion.co.uk
>>>>>
>>>>>
>>>>> Registered in England and Wales. Registered Number 3521142
>>>>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>>>>> Durham, DL3 7EH, UK
>>>>> VAT Number: GB 698 3633 78
>>>>>
>>>>> On 28/02/2015 18:38, Reindl Harald wrote:
>>>>>> Am 28.02.2015 um 19:13 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>>> I do not working with ipv6, I have disable, but I have the same
>>>>>>> error,
>>>>>>> I
>>>>>>> can read in internet that this ipv6 ip 2001:638:603:d06e::80:230:
>>>>>>> belong
>>>>>>> to url samba.org....
>>>>>>>
>>>>>>> If I try to connect to this url using some navegator I connected
>>>>>>> perfect....but when I run git pull using command line I can not
>>>>>>> connect..
>>>>>> the question is *how* did you disable ipv6 - when ifconfig shows a
>>>>>> "link local" ipv6 address the stack is *not* entirely disabled
>>>>>>
>>>>>> [root at srv-rhsoft:~]$ ifconfig eth0
>>>>>> eth0: flags=4419<UP,BROADCAST,RUNNING,PROMISC,MULTICAST> mtu 1500
>>>>>>           ether 24:be:05:1a:c0:27  txqueuelen 100  (Ethernet)
>>>>>>           RX packets 2460  bytes 577531 (563.9 KiB)
>>>>>>           RX errors 0  dropped 0  overruns 0  frame 0
>>>>>>           TX packets 8722  bytes 1981928 (1.8 MiB)
>>>>>>           TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>>>>>           device interrupt 20  memory 0xf7e00000-f7e20000
>>>>>>
>>>>>>>> Am 28.02.2015 um 15:37 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>>>>> Hello list, Iam using samba4 as Domain Controller my verion
>>>>>>>>> Version
>>>>>>>>> 4.3.0pre1-GIT-068f9e2, but I have a little problem when I going
>>>>>>>>> to
>>>>>>>>> update
>>>>>>>>> using GIT PULL I have this error
>>>>>>>>>
>>>>>>>>> error: Failed to connect to 2001:638:603:d06e::80:230: Network is
>>>>>>>>> unreachable while accessing
>>>>>>>>> http://git.samba.org/samba.git/info/refs
>>>>>>>>> fatal: HTTP request failed
>>>>>>>>>
>>>>>>>>> some body can helpme
>>>>>>>> do you have working ipv6?
>>>>>>>> if not disable it via sysctl.conf
>>>>>>>>
>>>>>>>> net.ipv6.conf.all.disable_ipv6=1
>>>>>>>> net.ipv6.conf.default.disable_ipv6=1
>>>>>>>>
>>>>>>>> that above is most likely because the link-local address if the
>>>>>>>> ipv6
>>>>>>>> stack is enabled and some piece of software thinks it's useable
>>>>>>>>
>>>>>>>> --
>>>>>>>> To unsubscribe from this list go to the following URL and read the
>>>>>>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>>>>
>>>>> --
>>>>> To unsubscribe from this list go to the following URL and read the
>>>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>>>
>>> --
>>> To unsubscribe from this list go to the following URL and read the
>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>
>>
>
> --
> To unsubscribe from this list go to the following URL and read the
> instructions:  https://lists.samba.org/mailman/options/samba
>

More information about the samba mailing list