[Samba] Samba4 start error

[Andrew Bartlett]

On Sun, 2011-02-27 at 22:36 +0100, Herczeg Péter wrote:
> Hello Andrew,
>  
> Thanks for the quick answer, I tried with the commands you advised,
> but no success. The same message, command/directory not found. (the
> directory you mentioned, is empty. ) instead of this folder was
> found /usr/local/samba/sbin#
> I have added libraries to PATH also.
>  
> What can be the problem? A previously installed Samba? 
> I have noticed, that smbclient cannot run also, it says cannot load
> smb.conf (the provision was successful previously)
>  
> Shall I investigate in the log files of compilation or installation?
> Or make a clean install of whole server?

Sorry for the confusion.  Please try again, following the steps in 
http://wiki.samba.org/index.php/Samba4/HOWTO exactly.

These steps are tested, and you seem to have followed them, but perhaps
you missed or mis-understood one of the steps. 

Andrew Bartlett
-- 
Andrew Bartlett                                http://samba.org/~abartlet/
Authentication Developer, Samba Team           http://samba.org
Samba Developer, Cisco Inc.