D-Link DWL 650 problems
Thomas Mattisson
thomas.mattisson at mobilearts.se
Sun Jan 6 02:34:56 EST 2002
Hi,
I've been trying to get my dlink card working under Linux using
orinoco_cs but it is a bit problematic. When using 2.4.17 and
pcmcia-cs 3.1.31 everything works fine for an hour or two and
then I get alot of the following:
Jan 4 23:11:53 maclay kernel: NETDEV WATCHDOG: eth0: transmit timed out
Jan 4 23:11:53 maclay kernel: eth0: Tx timeout! Resetting card.
Jan 4 23:11:53 maclay kernel: hermes @ 0x300: Timeout waiting for card
to reset (reg=0x0000)!
Jan 4 23:11:53 maclay kernel: eth0: Error -110 resetting card on Tx
timeout!
Jan 4 23:11:57 maclay kernel: NETDEV WATCHDOG: eth0: transmit timed out
Jan 4 23:11:57 maclay kernel: eth0: Tx timeout! Resetting card.
Jan 4 23:11:57 maclay kernel: eth0: Error -16 resetting card on Tx timeout!
If I remove the card and plug it back in, it works again.
I also tried to use version 0.09a of orinoco_cs with the above
but then it fails to initialize with the following messages:
Jan 5 16:18:17 maclay cardmgr[3257]: socket 1: D-Link DWL-650
Jan 5 16:18:17 maclay cardmgr[3257]: executing: 'modprobe hermes'
Jan 5 16:18:17 maclay cardmgr[3257]: executing: 'modprobe orinoco'
Jan 5 16:18:17 maclay cardmgr[3257]: executing: 'modprobe orinoco_cs '
Jan 5 16:18:17 maclay kernel: orinoco_cs: Card Services release does
not match!
Jan 5 16:18:17 maclay cardmgr[3257]: +
/lib/modules/2.4.17/pcmcia/orinoco_cs.o: init_module: Operation
not permitted
I have disabled the CONFIG_MODVERSIONS when compiling the kernel.
Anyone have any good suggestions?
/Thomas
More information about the wireless
mailing list