[Samba] kinit: Cannot contact any KDC for realm 'MY.LOCAL.' while getting initial credentials

[L.P.H. van Belle]

default_realm = MY.LOCAL.

remove the . at the end of MY.LOCAL. 

Greetz, 

Louis



> -----Oorspronkelijk bericht-----
> Van: samba [mailto:samba-bounces at lists.samba.org] Namens Rowland Penny
> Verzonden: dinsdag 15 september 2015 10:16
> Aan: samba at lists.samba.org
> Onderwerp: Re: [Samba] kinit: Cannot contact any KDC for realm 'MY.LOCAL.'
> while getting initial credentials
> 
> On 14/09/15 23:59, Lluís Danés wrote:
> > Hi,
> >
> > I've compiled and build samba 4.3.0 source using the samba wiki page and
> I
> > have run the next comands:
> >
> > (outside of the source folder)
> > 1- ./configure --with-acl-support
> > 2- make
> >
> > (also outside of the source4 folder since it give me some errors, the
> wiki
> > was wrong becuase it says inside)
> 
> Yes, that page is a bit misleading, If you are building samba from a git
> pull or a tarball, you usually end up with a directory holding all the
> samba source files i.e. samba-master for a git pull and samba-<version>
> for a tarball. You should cd into that directory and run the compile
> commands there. You also do not need to add '--with-acl-support' to the
> configure command, it is the default setting.
> 
> > 3- make install
> >
> > After that i set up the AD DC using the wiki page. All works but when i
> try:
> >
> > kinit administrator at MY.LOCAL it gives kinit: Cannot contact any KDC for
> > realm 'MY.LOCAL.' while getting initial credentials
> 
> It will probably help if you remove the trailing dot from the realm name
> in /etc/krb5.conf
> 
> Rowland
> 
> >
> > this is my configurations:
> >
> > /etc/hosts
> > 127.0.0.1       localhost.localdomain   localhost
> > 192.168.0.197   DEBIAN.my.local      DEBIAN
> >
> > /etc/resolv.conf
> > domain my.local
> > nameserver 192.168.0.197
> >
> > /usr/local/samba/etc/smb.conf
> > # Global parameters
> > [global]
> >          workgroup = MY
> >          realm = MY.LOCAL
> >          netbios name = DEBIAN
> >          server role = active directory domain controller
> >          dns forwarder = 8.8.8.8
> >          idmap_ldb:use rfc2307 = yes
> >
> > [netlogon]
> >          path = /usr/local/samba/var/locks/sysvol/my.local/scripts
> >          read only = No
> >          write ok = Yes
> >
> > [sysvol]
> >          path = /usr/local/samba/var/locks/sysvol
> >          read only = No
> >          write ok = Yes
> >
> >
> > /etc/krb5.conf
> > [libdefaults]
> >          default_realm = MY.LOCAL.
> >          dns_lookup_realm = false
> >          dns_lookup_kdc = true
> >
> >
> > This was the output of provision
> >
> > A Kerberos configuration suitable for Samba 4 has been generated at
> > /usr/local/samba/private/krb5.conf
> > Setting up fake yp server settings
> > Once the above files are installed, your Samba4 server will be ready to
> use
> > Server Role:           active directory domain controller
> > Hostname:              DEBIAN
> > NetBIOS Domain:        MY
> > DNS Domain:            my.local
> >
> >
> >
> > I dont know what happens :s, it was working yesterday using the debian
> > vendor's samba package (4.1.17-debian). Using the same steps. But now
> kinit
> > doesn't work anymore. The dns is resolved properely. I've tested all the
> > other things that the wiki setup for active directroy domain controller
> > says and all of them work.
> >
> >
> > Thanks in advance.
> >
> >
> >
> >
> >
> >
> 
> 
> --
> To unsubscribe from this list go to the following URL and read the
> instructions:  https://lists.samba.org/mailman/options/samba