[Samba] Update

Mon Mar 2 07:34:30 MST 2015

net.ipv6.conf.all.accept_ra = 1
net.ipv6.conf.all.autoconf = 1
net.ipv6.conf.eth0.accept_ra = 1
net.ipv6.conf.eth0.autoconf = 1
sysctl net.ipv6.conf.all.accept_ra
sysctl net.ipv6.conf.all.autoconf
sysctl net.ipv6.conf.eth0.accept_ra
sysctl net.ipv6.conf.eth0.autoconf


git pull
error: Failed to connect to 2001:638:603:d06e::80:230: Network is
unreachable while accessing http://git.samba.org/samba.git/info/refs
fatal: HTTP request failed


> in  /etc/gai.conf all is coment
>
>> Hi Sandy,
>>
>> Thanks! Curious. Do you have any other interfaces? ifconfig -a should
>> show them all including loopback.
>>
>> What is puzzling me is that it should not even attempt to use IPv6 to
>> reach a global address when it only has a link-local address. It should
>> gracefully fall back to IPv4 (as per RFC 6724 or RFC 3484 depending on
>> the kernel version). Since you have an IPv4 address and I assume an IPv4
>> connection, then this should work over IPv4.
>>
>> I'm assume that you do not have an /etc/gai.conf file installed?
>>
>> David
>> ------------------------------------------------------------------------
>> Dr David Holder CEng FIET MIEEE
>>
>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>
>> Reception: +44 (0)1422 207000
>>
>> Direct Dial: +44 (0)131 2026317
>>
>> http://www.erion.co.uk
>>
>>
>> Registered in England and Wales. Registered Number 3521142
>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>> Durham, DL3 7EH, UK
>> VAT Number: GB 698 3633 78
>>
>> On 02/03/2015 13:10, sandy.napoles at eccmg.cupet.cu wrote:
>>> eth0      Link encap:Ethernet  HWaddr d0:27:88:64:e4:01
>>>            inet addr:172.18.70.100  Mask:255.255.255.224
>>>            inet6 addr: fe80::d227:88ff:fe64:e401/64 Scope:Link
>>>            UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>>>            RX packets:1413908 errors:0 dropped:0 overruns:0 frame:0
>>>            TX packets:447039 errors:0 dropped:0 overruns:0 carrier:0
>>>            collisions:0 txqueuelen:1000
>>>            RX bytes:1693689457 (1.5 GiB)  TX bytes:52974612 (50.5 MiB)
>>>            Interrupt:43 Base address:0xc000
>>>
>>>
>>> traceroute6 git.samba.org
>>> traceroute to git.samba.org (2001:638:603:d06e::80:230), 30 hops max,
>>> 80
>>> byte packets
>>> connect: Network is unreachable
>>>
>>>
>>>
>>>
>>>> Hi Sandy,
>>>>
>>>> Please can you provide the output from an *i**fconfig -a* command?
>>>>
>>>> This should give an idea of what is going on. Turning off IPv6 will
>>>> not
>>>> be necessary if you can find the actual cause of the problem.
>>>>
>>>> You would not get this error message if you only have a link local
>>>> address configured on your interface. You must have some form of
>>>> global
>>>> address.
>>>>
>>>> Also, the IPv6 address is that of git.samba.org not samba.org. You
>>>> could
>>>> try:
>>>>
>>>> *traceroute6 git.samba.org.*
>>>>
>>>> Best Regards,
>>>> David
>>>> ------------------------------------------------------------------------
>>>> Dr David Holder CEng FIET MIEEE
>>>>
>>>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>>>
>>>> Reception: +44 (0)1422 207000
>>>>
>>>> Direct Dial: +44 (0)131 2026317
>>>>
>>>> http://www.erion.co.uk
>>>>
>>>>
>>>> Registered in England and Wales. Registered Number 3521142
>>>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>>>> Durham, DL3 7EH, UK
>>>> VAT Number: GB 698 3633 78
>>>>
>>>> On 28/02/2015 18:38, Reindl Harald wrote:
>>>>>
>>>>> Am 28.02.2015 um 19:13 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>> I do not working with ipv6, I have disable, but I have the same
>>>>>> error,
>>>>>> I
>>>>>> can read in internet that this ipv6 ip 2001:638:603:d06e::80:230:
>>>>>> belong
>>>>>> to url samba.org....
>>>>>>
>>>>>> If I try to connect to this url using some navegator I connected
>>>>>> perfect....but when I run git pull using command line I can not
>>>>>> connect..
>>>>> the question is *how* did you disable ipv6 - when ifconfig shows a
>>>>> "link local" ipv6 address the stack is *not* entirely disabled
>>>>>
>>>>> [root at srv-rhsoft:~]$ ifconfig eth0
>>>>> eth0: flags=4419<UP,BROADCAST,RUNNING,PROMISC,MULTICAST> mtu 1500
>>>>>          ether 24:be:05:1a:c0:27  txqueuelen 100  (Ethernet)
>>>>>          RX packets 2460  bytes 577531 (563.9 KiB)
>>>>>          RX errors 0  dropped 0  overruns 0  frame 0
>>>>>          TX packets 8722  bytes 1981928 (1.8 MiB)
>>>>>          TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>>>>          device interrupt 20  memory 0xf7e00000-f7e20000
>>>>>
>>>>>>> Am 28.02.2015 um 15:37 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>>>> Hello list, Iam using samba4 as Domain Controller my verion
>>>>>>>> Version
>>>>>>>> 4.3.0pre1-GIT-068f9e2, but I have a little problem when I going to
>>>>>>>> update
>>>>>>>> using GIT PULL I have this error
>>>>>>>>
>>>>>>>> error: Failed to connect to 2001:638:603:d06e::80:230: Network is
>>>>>>>> unreachable while accessing
>>>>>>>> http://git.samba.org/samba.git/info/refs
>>>>>>>> fatal: HTTP request failed
>>>>>>>>
>>>>>>>> some body can helpme
>>>>>>> do you have working ipv6?
>>>>>>> if not disable it via sysctl.conf
>>>>>>>
>>>>>>> net.ipv6.conf.all.disable_ipv6=1
>>>>>>> net.ipv6.conf.default.disable_ipv6=1
>>>>>>>
>>>>>>> that above is most likely because the link-local address if the
>>>>>>> ipv6
>>>>>>> stack is enabled and some piece of software thinks it's useable
>>>>>>>
>>>>>>> --
>>>>>>> To unsubscribe from this list go to the following URL and read the
>>>>>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>>>
>>>>>
>>>> --
>>>> To unsubscribe from this list go to the following URL and read the
>>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>>
>>>
>>
>> --
>> To unsubscribe from this list go to the following URL and read the
>> instructions:  https://lists.samba.org/mailman/options/samba
>>
>
>
> --
> To unsubscribe from this list go to the following URL and read the
> instructions:  https://lists.samba.org/mailman/options/samba
>