[Samba] Update

[sandy.napoles at eccmg.cupet.cu]

in  /etc/gai.conf all is coment

> Hi Sandy,
>
> Thanks! Curious. Do you have any other interfaces? ifconfig -a should
> show them all including loopback.
>
> What is puzzling me is that it should not even attempt to use IPv6 to
> reach a global address when it only has a link-local address. It should
> gracefully fall back to IPv4 (as per RFC 6724 or RFC 3484 depending on
> the kernel version). Since you have an IPv4 address and I assume an IPv4
> connection, then this should work over IPv4.
>
> I'm assume that you do not have an /etc/gai.conf file installed?
>
> David
> ------------------------------------------------------------------------
> Dr David Holder CEng FIET MIEEE
>
> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>
> Reception: +44 (0)1422 207000
>
> Direct Dial: +44 (0)131 2026317
>
> http://www.erion.co.uk
>
>
> Registered in England and Wales. Registered Number 3521142
> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
> Durham, DL3 7EH, UK
> VAT Number: GB 698 3633 78
>
> On 02/03/2015 13:10, sandy.napoles at eccmg.cupet.cu wrote:
>> eth0      Link encap:Ethernet  HWaddr d0:27:88:64:e4:01
>>            inet addr:172.18.70.100  Mask:255.255.255.224
>>            inet6 addr: fe80::d227:88ff:fe64:e401/64 Scope:Link
>>            UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>>            RX packets:1413908 errors:0 dropped:0 overruns:0 frame:0
>>            TX packets:447039 errors:0 dropped:0 overruns:0 carrier:0
>>            collisions:0 txqueuelen:1000
>>            RX bytes:1693689457 (1.5 GiB)  TX bytes:52974612 (50.5 MiB)
>>            Interrupt:43 Base address:0xc000
>>
>>
>> traceroute6 git.samba.org
>> traceroute to git.samba.org (2001:638:603:d06e::80:230), 30 hops max, 80
>> byte packets
>> connect: Network is unreachable
>>
>>
>>
>>
>>> Hi Sandy,
>>>
>>> Please can you provide the output from an *i**fconfig -a* command?
>>>
>>> This should give an idea of what is going on. Turning off IPv6 will not
>>> be necessary if you can find the actual cause of the problem.
>>>
>>> You would not get this error message if you only have a link local
>>> address configured on your interface. You must have some form of global
>>> address.
>>>
>>> Also, the IPv6 address is that of git.samba.org not samba.org. You
>>> could
>>> try:
>>>
>>> *traceroute6 git.samba.org.*
>>>
>>> Best Regards,
>>> David
>>> ------------------------------------------------------------------------
>>> Dr David Holder CEng FIET MIEEE
>>>
>>> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>>>
>>> Reception: +44 (0)1422 207000
>>>
>>> Direct Dial: +44 (0)131 2026317
>>>
>>> http://www.erion.co.uk
>>>
>>>
>>> Registered in England and Wales. Registered Number 3521142
>>> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
>>> Durham, DL3 7EH, UK
>>> VAT Number: GB 698 3633 78
>>>
>>> On 28/02/2015 18:38, Reindl Harald wrote:
>>>>
>>>> Am 28.02.2015 um 19:13 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>> I do not working with ipv6, I have disable, but I have the same
>>>>> error,
>>>>> I
>>>>> can read in internet that this ipv6 ip 2001:638:603:d06e::80:230:
>>>>> belong
>>>>> to url samba.org....
>>>>>
>>>>> If I try to connect to this url using some navegator I connected
>>>>> perfect....but when I run git pull using command line I can not
>>>>> connect..
>>>> the question is *how* did you disable ipv6 - when ifconfig shows a
>>>> "link local" ipv6 address the stack is *not* entirely disabled
>>>>
>>>> [root at srv-rhsoft:~]$ ifconfig eth0
>>>> eth0: flags=4419<UP,BROADCAST,RUNNING,PROMISC,MULTICAST> mtu 1500
>>>>          ether 24:be:05:1a:c0:27  txqueuelen 100  (Ethernet)
>>>>          RX packets 2460  bytes 577531 (563.9 KiB)
>>>>          RX errors 0  dropped 0  overruns 0  frame 0
>>>>          TX packets 8722  bytes 1981928 (1.8 MiB)
>>>>          TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>>>          device interrupt 20  memory 0xf7e00000-f7e20000
>>>>
>>>>>> Am 28.02.2015 um 15:37 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>>>> Hello list, Iam using samba4 as Domain Controller my verion Version
>>>>>>> 4.3.0pre1-GIT-068f9e2, but I have a little problem when I going to
>>>>>>> update
>>>>>>> using GIT PULL I have this error
>>>>>>>
>>>>>>> error: Failed to connect to 2001:638:603:d06e::80:230: Network is
>>>>>>> unreachable while accessing
>>>>>>> http://git.samba.org/samba.git/info/refs
>>>>>>> fatal: HTTP request failed
>>>>>>>
>>>>>>> some body can helpme
>>>>>> do you have working ipv6?
>>>>>> if not disable it via sysctl.conf
>>>>>>
>>>>>> net.ipv6.conf.all.disable_ipv6=1
>>>>>> net.ipv6.conf.default.disable_ipv6=1
>>>>>>
>>>>>> that above is most likely because the link-local address if the ipv6
>>>>>> stack is enabled and some piece of software thinks it's useable
>>>>>>
>>>>>> --
>>>>>> To unsubscribe from this list go to the following URL and read the
>>>>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>>
>>>>
>>> --
>>> To unsubscribe from this list go to the following URL and read the
>>> instructions:  https://lists.samba.org/mailman/options/samba
>>>
>>
>
> --
> To unsubscribe from this list go to the following URL and read the
> instructions:  https://lists.samba.org/mailman/options/samba
>