[Samba] Samba 3.0.20pre2 printer driver problem

[Joerg Pulz]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1


hi,

i tried to compile and run Samba 3.0.20pre2 on one of our servers 
yesterday. The servers OS is FreeBSD-5.4.
the configure run was okay, except for the aio part, but thats another 
point.
compiling went fine and installation too.
After starting smbd and nmbd i saw all printers but unfortunately all 
driver association where lost!
i found out, using rpcclient, that all printernames where converted to 
lowercase. In Samba 3.0.14a all printernames where uppercase.
i acted fast and switched back to 3.0.14a to make our clients happy.

here is an example output of rpcclient's "enumprinters 2" command that you 
can see the difference.

3.0.14a:
         servername:[\\mysrv]
         printername:[\\mysrv\LJ8150-PS]
         sharename:[LJ8150-PS]
         portname:[Samba Printer Port]
         drivername:[HP LaserJet 8150 PS]
         comment:[HP LaserJet 8150DN (Duplex, B/W)]
         location:[]

3.0.20pre2
         servername:[\\mysrv]
         printername:[\\mysrv\lj8150-ps]
         sharename:[LJ8150-PS]
         portname:[Samba Printer Port]
         drivername:[]
         comment:[HP LaserJet 8150DN (Duplex, B/W)]
         location:[]

can someone point me to a solution where i don't have to install/reassign 
all the printer drivers again?

another point, but thats only a minor-minor problem is, the comment 
field for the printer is filled with the information of the cups printing 
system, but the location field is left blank although this information is 
available in the cups printing system.

thanks for any help
Joerg

- -- 
The beginning is the most important part of the work.
 				-Plato
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (FreeBSD)

iD8DBQFC1hMjSPOsGF+KA+MRAn2jAJ9gQ1MU+kMnW86j/rOTBaB5WteHYwCfSBHn
5mos4o8pQk+EFXFmumnM0wc=
=B4WD
-----END PGP SIGNATURE-----