[Samba] Cable Modem
gmiller at eccbm.com
Sun Apr 6 14:26:23 GMT 2003
And what does this have to do with samba?
From: samba-bounces+gmiller=eccbm.com at lists.samba.org
[mailto:samba-bounces+gmiller=eccbm.com at lists.samba.org] On Behalf Of
Sent: Sunday, April 06, 2003 10:03 AM
To: samba at lists.samba.org
Subject: [Samba] Cable Modem
I read many postings in this listserv about cable modem under RHL 7.3 in
Sept 2002, I followed the recommendations, but I still can't get it to
work. I have 3 computers connected to an Ethernet hub/router in my
house, and the uplink from the hub/router goes to a Scientific-Atlanta
Webstar cable modem. The 2 Windows computers are successfully using the
cable modem to connect to the internet, my RHL 7.3 computer is not.
Here's what I did:
1) Ran "neat", the Network Configuration tool.
2) The "Devices" tab shows my eth0 connection as inactive.
3) I looked at the details of eth0, and on the "General" tab, I have the
radio button set to automatically obtain IP addresses using DHCP.
4) On the Router tab, I set the Subnet mask and Gateway with the values
from the output from the "ipconfig /all" command on the Windows XP
5) The "Hardware" tab shows my NIC card.
6) The "Hosts" tab has no entries on it.
7) The "DNS" tab has Hostname blank, has Primary, Secondary, and
Tertiary DNS valued with the TCP/IP addresses of my ISP's DNS Servers.
I got these values from the output from the "ipconfig /all" command on
the Windows XP machine.
When I click the Activate button from neat, it sits for about a minute,
then I get error message "Cannot activate network device eth0".
It is not a hardware problem, the NIC card worked fine before the cable
modem was installed, I used it to access the Windows machines on my home
network. At that time I was using static IP addresses.
Any ideas on what I'm doing wrong, or if I'm missing something?
Thank you, I appreciate your time.
To unsubscribe from this list go to the following URL and read the
More information about the samba