[Re: Interfaces]

[Jacob Eisinger]

After looking over my settings again, I found that the ip address I put in my
smb.conf did not match my ip address for my card - sorry for bothering the
list.  And, I had to comment a few lines line for the pdc.

Thanks,
Jacob

Dan Egli <cybrgeek at xmission.com> wrote:
> Realise that thats a Pretty small netmask! 252 is (if I remember) a total
> of FOUR addresses that do not need to be routed. Are you SURE thats the
> correct netmask? Last time I saw the 10. addresses in use, there was a
> class A subnet mask to go with it (255.0.0.0).
> 
> On 16 Sep 2000, Jacob Eisinger wrote:
> 
> > I would like my linux computer to use samba only on my high school's
internal
> > network.
> > 
> > I currently have my ethernet card set up to use a real IP address
> > (168.216.25.74/255.255.255.0); I would like the computer to respond my
> > internal network, some 10 dot addresses.
> > 
> > Can you tell me why this does not work:
> > 
> >    Open linuxconf and add the IP address 10.160.63.151, netmask
> > 255.255.255.252 in the "IP aliases for virtual hosts" section.
> > 
> >    Then in Samba add this to my [global] options:
> >      interfaces = 10.160.63.151/255.255.255.252
> >      bind interfaces only = yes
> > 
> > This would allow me to see this computer in Network Neighborhood on a
windows
> > 95 computer, right?
> > 
> > Thanks,
> > Jacob Eisinger
> > gwhs.kana.k12.wv.us
> > 
> > ____________________________________________________________________
> > Get free email and a permanent address at http://www.netaddress.com/?N=1
> > 
> > 
> 


____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1