Did anybody test smbclient4 against smbd4 using SMB2

[Jun Yi]

Thanks Andrew.

I found the code path for smbclient4 is up to date at most of 2007. So it
may be outdated. I also found the code path for smbclient is outdated too.
smbclient is older than smbclient4 and it can only supports smb1. I type
"smbclient -m SMB2 //server/share"  and get message "SMB2 protocol
unrecognized".

I have the following two questions:
1: how to build smbtorture in the master branch. Does smbtorture support
SMB2? Did anybody use smbtorture to test against smbd daily? Where can I
find the document for smbtorture---smbd  tests.
2: Did anybody use smbtorture to test against windows servers (for example
windows 7 or windows server 2008 R2). Could you please tell me how to do
that and where I can find the document?
3: I read a little of smbtorture source code (I will read more). I know
where to add a new test case into the framework. To add a runnable test
case, what part of the source codes should I read. Should I read the entire
source code?

Thanks and wait for your reply

Jun

On Tue, Sep 25, 2012 at 2:08 PM, Andrew Bartlett <abartlet at samba.org> wrote:

> On Tue, 2012-09-25 at 10:43 -0700, Jun Yi wrote:
> > Thanks Andrew,
> >
> > Let's first clarify the version I used. I use the master branch, e.g.,
> > version 4.1.0, for both client and server sides.
> >
> > I run smbclient4 at the client side:
> > junyij at junyij] ./smbclient4
> > -V
> >     Version 4.1.0pre1-DEVELOPERBUILD
> > junyij at junyij] ./smbclient4 -m SMB2 -W smb-workgroup -U
> > junyij //localhost/share1
> > Connection to \\localhost\share1 failed - NT_STATUS_REVISION_MISMATCH
> >
> > I run sbmd at the server side with configuration
> > file /etc/samba/smb.conf
> > junyij at junyij] sudo ./smbd
> > -V
> >     Version 4.1.0pre1-DEVELOPERBUILD
> > sudo ./smbd -s /etc/samba/smb.conf -d 10 -l smbd-4
> > junyij at junyij]
> > cat /etc/samba/smb.conf
> > [global]
> > workgroup = smb-workgroup
> > max protocol = SMB2
> > min protocol = SMB2
> > [share1]
> > path = /tmp
>
> I examined the source code used by smbclient4, and as far as I can tell
> this tool simply cannot do smb2.  Therefore, as you have seen, this will
> fail.
>
> You could try 'smbclient' (which uses a different codebase), which
> appears to have some support, but I'm not sure exactly how much is
> connected there.
>
> Andrew Bartlett
>
> --
> Andrew Bartlett                                http://samba.org/~abartlet/
> Authentication Developer, Samba Team           http://samba.org
>
>
>