Samba 2.2.4 printer properties
Thomas.Mieslinger at germanparcel.de
Thomas.Mieslinger at germanparcel.de
Fri Jun 14 06:51:06 GMT 2002
Hi,
I'm using Samba 2.2.4 on Solaris/intel as PDC with WinNT Clients.
When I try to display the printer properties or to install a new driver,
then sometimes the whole AddPrinterWizard is greyed out. When I wait for
some time, then the AddPrinterWizard is useable again. The previous 2.2.1a
did have this feature (but others).
I used this command to configure samba:
./configure --prefix=/usr/local --localstatedir=/var/samba
--with-privatedir=/etc/samba --with-lockdir=/var/samba/locks
--with-piddir=/var/samba/run --with-configdir=/etc/samba
--with-codepagedir=/usr/local/share/codepages
--with-logfilebase=/var/samba/log --with-pam --with-pam_smbpass
--with-nisplussam --with-quotas --with-acl-support --without-winbind
Is this problem known?
TIA
Thomas Mieslinger
--
German Parcel
Thomas Mieslinger
German-Parcel-Str. 1-7 fon: +49 6677 17 463
36286 Neuenstein fax: +49 6677 17 111
Germany eMail: thomas.mieslinger at germanparcel.de
More information about the samba-technical
mailing list