[distcc] IPv6 support in distccd?
Andre-John Mas
ajmas at sympatico.ca
Fri Jun 10 06:47:01 MDT 2011
Hi,
Is there any reason IPv6 support is not enabled by default? I am thinking more aligns, are what is the negative impact if it is?
Andre
On 9-Jun-2011, at 14:44, Fergus Henderson wrote:
> You need to configure distcc with --enable-rfc2553 for IPv6 support.
>
> Then the syntax should be just standard IPv6 address syntax,
> e.g. see http://en.wikipedia.org/wiki/CIDR_notation.
>
> The relevant function is dcc_parse_mask() in src/access.c (and dcc_check_address()).
>
> On Thu, Jun 9, 2011 at 12:39 PM, Vanush Misha <misha at cs.nuim.ie> wrote:
> Hi List,
>
> I couldn't figure out how to use IPv6 addresses with the --allow option
> of distccd. It is not documented at all. I don't want to use avahi
> zeroconf option, just want to allow a single IPv6 IP address to
> connect. I thought I ask on this list before diving into the source
> codes.
>
> Thanks in advance,
>
> Misha.
>
> --
> Vanush "Misha" Paturyan
> Senior Technical Officer
> Computer Science Department
> NUI Maynooth
>
> __
> distcc mailing list http://distcc.samba.org/
> To unsubscribe or change options:
> https://lists.samba.org/mailman/listinfo/distcc
>
>
>
> --
> Fergus Henderson <fergus at google.com>
>
> "Defend the user, exclude no one, and create magic." -- Eric Schmidt.
>
>
> __
> distcc mailing list http://distcc.samba.org/
> To unsubscribe or change options:
> https://lists.samba.org/mailman/listinfo/distcc
More information about the distcc
mailing list