[IPAQ] Probleme with orinoco/orinoco_cs/hermes

[Sebastien Chenevotot]

Hi,

I'm using Familiar v8.2 on a ipaq 3800. My kernel is Linux h3600
2.4.19-rmk6-pxa1-hh37.
orinoco_cs 0.13e works fine but I can't use "iwlist eth0 scan".
I upgraded to 0.15rc2 but it does not work properly. Some packets are lost and
dmesg says a lot of:
hermes @ IO 0xccad0000: BAP0 offset error: reg=0x0 id=0xc0 offset=0x44
eth0: Error -5 writing packet to BAP

"iwlist eth0 scan" gives
eth0      Failed to read scan data : Resource temporarily unavailable


My card s a Compaq WL 110 and that is an interesting part of what dmesg tells:

orinoco 0.15rc2STA (David Gibson <hermes at gibson.dropbear.id.au>, Pavel Roskin
<proski at gnu.org>, et al)
dma period = 1398056 ps, clock = 206400 kHz
dma period = 1398056 ps, clock = 206400 kHz
orinoco_cs 0.15rc2STA (David Gibson <hermes at gibson.dropbear.id.au>, Pavel Roskin
<proski at gnu.org>, et al)
eth0: Hardware identity 0001:0001:0004:0002
eth0: Station identity  001f:0001:0006:0010
eth0: Firmware determined as Lucent/Agere 6.16
eth0: Ad-hoc demo mode supported
eth0: IEEE standard IBSS ad-hoc mode supported
eth0: WEP supported, 104-bit key
eth0: MAC address 00:02:A5:6E:96:3F
eth0: Station name "HERMES I"
eth0: ready
eth0: index 0x01: Vcc 5.0, irq 42, io 0xccad0000-0xccad003f
dma period = 1398056 ps, clock = 206400 kHz
eth0: New link status: Connected (0001)
hermes @ IO 0xccad0000: BAP1 offset error: reg=0x4 id=0xfd42 offset=0x0

I don't know where the problem exactly is. How can I fix that thing?
Thanks !


Cheers,

Sebastien