problems with new card
Rob
rwideman at austin.rr.com
Fri Nov 8 18:00:20 EST 2002
I cant figure out why I cant get my wireless card to work. Help please.
Here are the outputs for all the commands.
This is a RH 7.3 w/ 2.4.19 with the modules built in (all nics).
Has a Orinoco/Lucent Technologies PCMCIA->PCI card with 2 PCI NIC's.
Thanks
[root at localhost root]# dump_cis
Socket 0:
cs: warning: no high memory space available!
cs: unable to map card memory!
cs: unable to map card memory!
no CIS present
[root at localhost root]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:04:5A:4C:CD:2D
inet addr:192.168.13.41 Bcast:192.168.13.255 Mask:255.255.255.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:368 errors:0 dropped:0 overruns:0 frame:0
TX packets:301 errors:4 dropped:0 overruns:0 carrier:8
collisions:0 txqueuelen:100
RX bytes:28918 (28.2 Kb) TX bytes:44680 (43.6 Kb)
Interrupt:15 Base address:0x7400
eth1 Link encap:Ethernet HWaddr 00:C0:F0:75:C4:29
inet addr:10.10.10.5 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:4 dropped:0 overruns:0 carrier:8
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11 Base address:0x7800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
[root at localhost root]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 no wireless extensions.
gre0 no wireless extensions.
[root at localhost root]# dmesg
Linux version 2.4.19 (root at localhost.localdomain) (gcc version 2.96 20000731
(Red Hat Linux 7.3 2.96-110)) #1 SMP Tue Sep 17 08:18:55 CDT 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000000fffda40 (usable)
BIOS-e820: 000000000fffda40 - 0000000010000000 (ACPI data)
BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)
BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved)
BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved)
255MB LOWMEM available.
On node 0 totalpages: 65533
zone(0): 4096 pages.
zone(1): 61437 pages.
zone(2): 0 pages.
IBM machine detected. Enabling interrupts during APM calls.
Kernel command line: ro root=/dev/hda2
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
Detected 266.618 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 530.84 BogoMIPS
Memory: 256892k/262132k available (1104k kernel code, 4852k reserved, 422k
data, 96k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0080fbff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
CPU: After vendor init, caps: 0080fbff 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0080fbff 00000000 00000000 00000000
CPU: Common caps: 0080fbff 00000000 00000000 00000000
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
CPU: Before vendor init, caps: 0080fbff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
CPU: After vendor init, caps: 0080fbff 00000000 00000000 00000000
Intel machine check reporting enabled on CPU#0.
CPU: After generic, caps: 0080fbff 00000000 00000000 00000000
CPU: Common caps: 0080fbff 00000000 00000000 00000000
CPU0: Intel Pentium II (Klamath) stepping 04
per-CPU timeslice cutoff: 1464.17 usecs.
SMP motherboard not detected.
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000000
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 266.6310 MHz.
..... host bus clock speed is 66.6576 MHz.
cpu: 0, clocks: 666576, slice: 333288
CPU0<T0:666576,T1:333280,D:8,S:333288,C:666576>
Waiting on wait_init_idle (map = 0x0)
All processors have done init_idle
PCI: PCI BIOS revision 2.10 entry at 0xfd88c, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
PCI: Found IRQ 9 for device 00:14.0
PCI: Sharing IRQ 9 with 01:00.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
pty: 256 Unix98 ptys configured
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfff0-0xfff7, BIOS settings: hda:pio, hdb:DMA
hda: ST51270A, ATA DISK drive
hdb: ATAPI 48X CDROM, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 2504880 sectors (1282 MB) w/128KiB Cache, CHS=621/64/63, DMA
hdb: ATAPI 48X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
hda: hda1 hda2 hda3
FDC 0 is a post-1991 82077
Linux Tulip driver version 0.9.15-pre11 (May 11, 2002)
PCI: Found IRQ 15 for device 00:10.0
eth0: ADMtek Comet rev 17 at 0x7400, 00:04:5A:4C:CD:2D, IRQ 15.
PCI: Found IRQ 11 for device 00:12.0
eth1: Lite-On PNIC-II rev 37 at 0x7800, 00:C0:F0:75:C4:29, IRQ 11.
Linux Kernel Card Services 3.1.22
options: [pci] [cardbus]
PCI: Enabling device 00:14.0 (0000 -> 0002)
PCI: Found IRQ 9 for device 00:14.0
PCI: Sharing IRQ 9 with 01:00.0
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
GRE over IPv4 tunneling driver
Yenta IRQ list 0000, PCI irq9
Socket status: 10000011
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
802.1Q VLAN Support v1.7 Ben Greear <greearb at candelatech.com>
All bugs added by David S. Miller <davem at redhat.com>
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 96k freed
Adding Swap: 320536k swap-space (priority -1)
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,2), internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on ide0(3,1), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
hdb: DMA disabled
cs: warning: no high memory space available!
cs: unable to map card memory!
cs: unable to map card memory!
[root at localhost root]# cd /etc/pcmcia/
[root at localhost pcmcia]# cat wireless.opts
case "$ADDRESS" in
# Pick up any Access Point, should work on most 802.11 cards
#essidany,*,*,*)
# INFO="Any ESSID"
# ESSID="any"
# ;;
# Here are a few examples with a few Wireless LANs supported...
# The matching is done on the first 3 bytes of the MAC address
# Generic example (decribe all possible settings)
*,*,*,*)
INFO="kldlads"
# ESSID (extended network name) : My Network, any
#ESSID=""
# NWID/Domain (cell identifier) : 89AB, 100, off
NWID="kldlads"
# Operation mode : Ad-Hoc, Managed, Master, Repeater, Secondary, auto
MODE="Master"
# Frequency or channel : 1, 2, 3 (channel) ; 2.422G, 2.46G (frequency)
FREQ="2.46G"
CHANNEL="2"
# Sensitivity (cell size + roaming speed) : 1, 2, 3 ; -70 (dBm)
SENS=""
# Bit rate : auto, 1M, 11M
RATE="11M"
# ncryption key : 4567-89AB-CD, s:password
#KEY=""
# RTS threshold : off, 500
RTS="auto"
# Fragmentation threshold : off, 1000
FRAG="auto"
# Other iwconfig parameters : power off, ap 01:23:45:67:89:AB
IWCONFIG=""
IPADDR="192.168.2.1"
NETMASK="255.255.255.0"
NETWORK="192.168.2.0"
BROADCAST="192.168.2.255"
#DNS_1=""
# iwspy parameters : + 01:23:45:67:89:AB
#IWSPY=""
# iwpriv parameters : set_port 2, set_histo 50 60
#IWPRIV=""
;;
[root at localhost pcmcia]#
[root at localhost pcmcia]#
More information about the wireless
mailing list