D-Link DWL-650H

[Johnny Shih]

Hi guys,
new to this mailing list. Hope I can gain some help from you all as well 
as be contributive here in the future.

I have heard only orinoco's driver will work with D-Link 
DWL-650H,unfortunately I can't seem to get it to work..
I was using pcmcia-cs-3.2.0 and orinoco-0.12b driver. I had no trouble 
configure/compile/install the drivers....obviously the card isn't 
initialised properly by returning following errors (after running 
/etc/rc.d/init.d/pcmcia restart):

Jul 30 15:20:39 localhost cardmgr[2771]: executing: 'modprobe -r orinoco_cs'
Jul 30 15:20:39 localhost cardmgr[2771]: executing: 'modprobe -r orinoco'
Jul 30 15:20:39 localhost cardmgr[2771]: executing: 'modprobe -r hermes'
Jul 30 15:20:39 localhost cardmgr[2771]: exiting
Jul 30 15:20:41 localhost cardmgr[2837]: watching 1 sockets
Jul 30 15:20:41 localhost kernel: cs: IO port probe 0x0c00-0x0cff: clean.
Jul 30 15:20:41 localhost kernel: cs: IO port probe 0x0100-0x04ff: 
excluding 0x4d0-0x4d7
Jul 30 15:20:41 localhost kernel: cs: IO port probe 0x0a00-0x0aff: clean.
Jul 30 15:20:41 localhost cardmgr[2838]: starting, version is 3.2.0
Jul 30 15:20:41 localhost cardmgr[2838]: socket 0: D-Link DWL-650H 
11Mbps 802.11b WLAN Card
Jul 30 15:20:41 localhost cardmgr[2838]: executing: 'modprobe hermes'
Jul 30 15:20:41 localhost cardmgr[2838]: executing: 'modprobe orinoco'
Jul 30 15:20:41 localhost cardmgr[2838]: executing: 'modprobe orinoco_cs'
Jul 30 15:20:41 localhost kernel: eth1: failed to initialize firmware 
(err = -16)
Jul 30 15:20:41 localhost kernel: orinoco_cs: register_netdev() failed
Jul 30 15:20:42 localhost cardmgr[2838]: get dev info on socket 0 
failed: Resource temporarily unavailable

any help would be very much appreciated..
thanks in advance
Johnny