[Samba] Dcs Replication

[Carlos]

Hi!

In Option "Inter-Site Transports", i have only  one the name 
"DEFAULTIPSITELINK" , in properties

Sites in this link:

Matriz
Filial

Matriz -> site with DC1 and DC2
Filail ->  site With DC3

Regards;


On 17-05-2018 13:12, lingpanda101 wrote:
> On 5/17/2018 12:07 PM, Carlos wrote:
>> Hi!
>>
>> Thanks for answer.
>>
>> But, i allowed all ports in my firewall...
>>
>> I tested, shutdown  my DC1
>>
>> DC2 dont comunication with DC3
>>
>> I create user in DC2, dont replication with DC3...
>> I waited more in 20 minutes
>>
>> Why ??
>>
>> Regards;
>>
>>
>> On 17-05-2018 12:01, lingpanda101 wrote:
>>> On 5/17/2018 10:30 AM, Carlos via samba wrote:
>>>> Hi!
>>>>
>>>> I have 2 DC, now add one more DC, but all dcs dont view between they.
>>>>
>>>> New DC is "DC2"
>>>>
>>>> DC1 - vlan10 -> OK to DC3(Connectad by openvpn)
>>>>
>>>> DC1 -> vlan10 -> OK to DC2(vlan50)
>>>>
>>>> DC2-> vlan50 -> OK to DC1(vlan10)
>>>>
>>>> DC2-> Openvpn -> Dont "see" DC3
>>>>
>>>> DC3 -> Openvpn -> OK to DC1(vlan10)
>>>>
>>>> DC3 -> Openvpn -> Dont "view" DC2(vlan50)
>>>>
>>>> All version Dcs Samba 4.7.7
>>>> Firewall is allow  between they.
>>>>
>>>> -----
>>>>
>>>> DC1
>>>>
>>>> samba-tool drs showrepl
>>>>
>>>> I see only DC2 and DC3 is OK
>>>> Is correct.
>>>>
>>>> DC2
>>>>
>>>> samba-tool drs showrepl
>>>>
>>>> I see only DC1
>>>>
>>>> DC3
>>>>
>>>> samba-tool drs showrepl
>>>>
>>>> I see only DC1
>>>> ------------------------
>>>>
>>>> Any Ideia ?
>>>>
>>>>
>>>> Regards
>>>>
>>>>
>>> Carlos,
>>>
>>>     This is normal if your firewall is working correctly. The KCC 
>>> checks and creates replication links to optimize latency and cost 
>>> where needed. You can override this and create a full mesh topology 
>>> with the following in your smb.conf under 'Global'.
>>>
>>> kccsrv:samba_kcc=No
>>>
>>> I advise not doing this but instead ensure sites and services are 
>>> setup correctly for your IP Inter-Site-Transports. You can define 
>>> cost and interval for the links here.
>>>
>>>
>>> -James
>>>
>>>
>>
> Did you verify you have the Inter-Site Transports configured properly 
> in Active Directory Sites and Services snap in?
>
> -James
>