[Samba] Dcs Replication

[lingpanda101]

On 5/17/2018 10:30 AM, Carlos via samba wrote:
> Hi!
>
> I have 2 DC, now add one more DC, but all dcs dont view between they.
>
> New DC is "DC2"
>
> DC1 - vlan10 -> OK to DC3(Connectad by openvpn)
>
> DC1 -> vlan10 -> OK to DC2(vlan50)
>
> DC2-> vlan50 -> OK to DC1(vlan10)
>
> DC2-> Openvpn -> Dont "see" DC3
>
> DC3 -> Openvpn -> OK to DC1(vlan10)
>
> DC3 -> Openvpn -> Dont "view" DC2(vlan50)
>
> All version Dcs Samba 4.7.7
> Firewall is allow  between they.
>
> -----
>
> DC1
>
> samba-tool drs showrepl
>
> I see only DC2 and DC3 is OK
> Is correct.
>
> DC2
>
> samba-tool drs showrepl
>
> I see only DC1
>
> DC3
>
> samba-tool drs showrepl
>
> I see only DC1
> ------------------------
>
> Any Ideia ?
>
>
> Regards
>
>
Carlos,

     This is normal if your firewall is working correctly. The KCC 
checks and creates replication links to optimize latency and cost where 
needed. You can override this and create a full mesh topology with the 
following in your smb.conf under 'Global'.

kccsrv:samba_kcc=No

I advise not doing this but instead ensure sites and services are setup 
correctly for your IP Inter-Site-Transports. You can define cost and 
interval for the links here.


-James