[Samba] ADS domain member: winbind fails

[Rowland Penny]

On Fri, 30 Dec 2016 17:24:53 +0100
"Stefan G. Weichinger via samba" <samba at lists.samba.org> wrote:

> Am 2016-12-30 um 17:01 schrieb Rowland Penny via samba:
> 
> > If everything is setup as above you should be able to join the
> > gentoo domain member to the domain and then start the nmbd, smbd
> > and winbind deamons.
> 
> sad to say:
> 
> leave and join works without a problem, but then ->
> 
>   winbindd.service - Samba Winbind daemon
>     Loaded: loaded (/usr/lib64/systemd/system/winbindd.service; 
> disabled; vendor preset: enabled)
>     Active: failed (Result: signal) since Fr 2016-12-30 17:22:46 CET;
> 5s ago Process: 2540 ExecStart=/usr/sbin/winbindd -D (code=exited, 
> status=0/SUCCESS)
>   Main PID: 2543 (code=killed, signal=ABRT)
> 
> Dez 30 17:22:46 main.arbeitsgruppe.secret.tld systemd[1]: Starting
> Samba Winbind daemon...
> Dez 30 17:22:46 main.arbeitsgruppe.secret.tld systemd[1]: Started
> Samba Winbind daemon.
> Dez 30 17:22:46 main.arbeitsgruppe.secret.tld systemd[1]: 
> winbindd.service: Main process exited, code=killed, status=6/ABRT
> Dez 30 17:22:46 main.arbeitsgruppe.secret.tld systemd[1]: 
> winbindd.service: Unit entered failed state.
> Dez 30 17:22:46 main.arbeitsgruppe.secret.tld systemd[1]: 
> winbindd.service: Failed with result 'signal'.
> 
> 
> ->
> 
> main samba # wbinfo -u
> could not obtain winbind interface details:
> WBC_ERR_WINBIND_NOT_AVAILABLE could not obtain winbind domain name!
> Error looking up domain users
> 
> ---
> 
> 
> 

OK, try this, open a terminal, type 'winbindd -i'
This should directly run winbind in the terminal, hopefully if it fails
it will print an error message, if not try again but add '-d3'

Rowland