[Samba] Update

[sandy.napoles at eccmg.cupet.cu]

eth0      Link encap:Ethernet  HWaddr d0:27:88:64:e4:01
          inet addr:172.18.70.100  Mask:255.255.255.224
          inet6 addr: fe80::d227:88ff:fe64:e401/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1413908 errors:0 dropped:0 overruns:0 frame:0
          TX packets:447039 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1693689457 (1.5 GiB)  TX bytes:52974612 (50.5 MiB)
          Interrupt:43 Base address:0xc000


traceroute6 git.samba.org
traceroute to git.samba.org (2001:638:603:d06e::80:230), 30 hops max, 80
byte packets
connect: Network is unreachable




> Hi Sandy,
>
> Please can you provide the output from an *i**fconfig -a* command?
>
> This should give an idea of what is going on. Turning off IPv6 will not
> be necessary if you can find the actual cause of the problem.
>
> You would not get this error message if you only have a link local
> address configured on your interface. You must have some form of global
> address.
>
> Also, the IPv6 address is that of git.samba.org not samba.org. You could
> try:
>
> *traceroute6 git.samba.org.*
>
> Best Regards,
> David
> ------------------------------------------------------------------------
> Dr David Holder CEng FIET MIEEE
>
> Erion Ltd, An Cala, Inverkirkaig, Lochinver, Sutherland, IV27 4LR, UK
>
> Reception: +44 (0)1422 207000
>
> Direct Dial: +44 (0)131 2026317
>
> http://www.erion.co.uk
>
>
> Registered in England and Wales. Registered Number 3521142
> Registered Office: Newtons, 49 Coniscliffe Road, Darlington, County
> Durham, DL3 7EH, UK
> VAT Number: GB 698 3633 78
>
> On 28/02/2015 18:38, Reindl Harald wrote:
>>
>>
>> Am 28.02.2015 um 19:13 schrieb sandy.napoles at eccmg.cupet.cu:
>>> I do not working with ipv6, I have disable, but I have the same error,
>>> I
>>> can read in internet that this ipv6 ip 2001:638:603:d06e::80:230:
>>> belong
>>> to url samba.org....
>>>
>>> If I try to connect to this url using some navegator I connected
>>> perfect....but when I run git pull using command line I can not
>>> connect..
>>
>> the question is *how* did you disable ipv6 - when ifconfig shows a
>> "link local" ipv6 address the stack is *not* entirely disabled
>>
>> [root at srv-rhsoft:~]$ ifconfig eth0
>> eth0: flags=4419<UP,BROADCAST,RUNNING,PROMISC,MULTICAST> mtu 1500
>>         ether 24:be:05:1a:c0:27  txqueuelen 100  (Ethernet)
>>         RX packets 2460  bytes 577531 (563.9 KiB)
>>         RX errors 0  dropped 0  overruns 0  frame 0
>>         TX packets 8722  bytes 1981928 (1.8 MiB)
>>         TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
>>         device interrupt 20  memory 0xf7e00000-f7e20000
>>
>>>> Am 28.02.2015 um 15:37 schrieb sandy.napoles at eccmg.cupet.cu:
>>>>> Hello list, Iam using samba4 as Domain Controller my verion Version
>>>>> 4.3.0pre1-GIT-068f9e2, but I have a little problem when I going to
>>>>> update
>>>>> using GIT PULL I have this error
>>>>>
>>>>> error: Failed to connect to 2001:638:603:d06e::80:230: Network is
>>>>> unreachable while accessing http://git.samba.org/samba.git/info/refs
>>>>> fatal: HTTP request failed
>>>>>
>>>>> some body can helpme
>>>>
>>>> do you have working ipv6?
>>>> if not disable it via sysctl.conf
>>>>
>>>> net.ipv6.conf.all.disable_ipv6=1
>>>> net.ipv6.conf.default.disable_ipv6=1
>>>>
>>>> that above is most likely because the link-local address if the ipv6
>>>> stack is enabled and some piece of software thinks it's useable
>>>>
>>>> --
>>>> To unsubscribe from this list go to the following URL and read the
>>>> instructions:  https://lists.samba.org/mailman/options/samba
>>
>>
>>
>
> --
> To unsubscribe from this list go to the following URL and read the
> instructions:  https://lists.samba.org/mailman/options/samba
>