[Samba] Wrong interface on AD Provisioning

[Rowland penny]

On 27/12/15 18:41, Viktor Trojanovic wrote:
> When I provisioned a new AD domain, I used the wrong network interface 
> in the provisioning command.
>
> samba-tool domain provision --option="interfaces=lo eth2" 
> --option="bind interfaces only=yes" --use-rfc2307 --use-xattrs=yes 
> --interactive
>
> I should have used eth1 instead of eth2. The latter had no IP address 
> attached to it so that there is no (correct) A record in the internal 
> DNS for the DC. At any rate host -t A dc.samdom.domain.com is 
> returning an error (Host not found: 3(NXDOMAIN)).
>
> How can I correct this *without* MS Windows RSAT? Can I just run the 
> same command again and it will overwrite the previous config?
>

Remove smb.conf and then re-provision

Rowland