[Samba] smbd start trouble - CentOS 5.4
grantliddle at gmail.com
Thu May 27 22:50:39 MDT 2010
On Thu, May 27, 2010 at 1:16 AM, Moray Henderson <
Moray.Henderson at ict-software.org> wrote:
> Whit Blauvelt wrote:
> >With smbd Version 3.0.33-3.14.el5 on two different CentOS 5.4 64-bit
> >"/etc/init.d/smb start" reports OK for both nmbd and smbd, but an
> >later smbd stops running, with no errors reported - just fails, no
> >what logging level is requested of it. Also, "service smb start" fails.
> >On the other hand, "smbd -D" starts and runs smbd just fine, if done
> >console. Also "sh /etc/init.d/smb start" runs it just fine, if from a
> >console. (sh = bash on CentOS, and the smb script itself specifies
> That feels as if it could be an SELinux problem. If your initscript has
> been edited and picked up the wrong context, smbd will not have all the
> permissions it normally gets. Try
> ls -Z /etc/rc.d/init.d/smb
> restorecon -v /etc/rc.d/init.d/smb
> "To err is human. To purr, feline"
To test if it is selinux you might try with selinux set to permissive. I
had all kinds of troubles getting samba 3.0.33 working on centos 5.4, 64-bit
until I tried that. Good luck.
More information about the samba