[Samba] Samba 3.0.14 - very puzzling domain browsing problems

[Stephen Bosch]

Anthony Messina wrote:
> stephen, might you try setting:
> 
> hosts allow = 10.0.0.0/8
> 
> or change the network/mask bit for each lan you'd like to allow
> 
> and:
> hosts deny = 0.0.0.0/0
> 
> and:
> interfaces = eth0
> bind interfaces only = yes
> 
> change eth0 to whatever eth* interface your lan is connected to, and
> also add "lo" if you use printers attached to this samba server.  this
> will tell samba to only bind to the interfaces that you have configured
> here and may route broswing properly.
> 
> anyone else here have any suggestions?

We did

interfaces = 10.10.10.12/24

and

remote announce = 10.10.10.255/HEDLIN-LAUDER

following the smb.conf man page, but that had no discernable effect.

-Stephen-