[Samba] PRINT$ Problems
Ryan Suarez
ryan.suarez at sheridanc.on.ca
Tue Jun 15 14:18:57 GMT 2004
Hi Aaron,
Are you using CUPS for printing?
If so:
What printer drivers are you using? What PPD? Did you use cupsaddsmb
to install the printer drivers to samba?
Can we see your global section for smb.conf?
Aaron Goodman wrote:
>I have been trying to setup point and print on a debian testing box. I have
>a HP5550 printer and am trying to install the drivers through the add
>printer wizard, the drivers appeared to install fine. Afterwards I right
>clicked on the printer and clicked connect, per the SAMBA howto, this also
>appeared to work. When I tried to enter the properties screen of the local
>printer or on the share I get the following error message:
>"Function address 0x60630d26 caused a protection fault. (exception code
>0xc0000005)
>Some or all property page(s) may not be displayed)."
>After the error message comes up, the properties window does not open. I
>cannot print either.
>
>Here is the relavent section from my smb.conf:
>
>-----
>[printers]
> comment = All Printers
> browseable = yes
> printable = yes
> path = /tmp
> writable = yes
> create mode = 0700
>
>[print$]
> path = /etc/samba/drivers
> browsable = no
> guest ok = yes
> read only = yes
> write list = aaron root
>------
>
>Thanks,
>Aaron Goodman
>
>
>
More information about the samba
mailing list