[Samba] (no subject)

[graemew at excoeng.com]

I am on Solaris 8 with Samba 2.2.4.  When I configure a printer it sets
'oplocks = No' in the printer share.  When I run testparm it then gives me
an error message;

Invalid combination of parameters for service insp0101. Level II oplocks
can only be set if oplocks are also set.

The dump shows that in the [global] section 'oplocks' and 'level2 oplocks'
are both set to the default Yes.  If I manually change 'oplocks = Yes' in
the printer share, testparm runs clean.  Why would using SWAT put this
entry in a printer share?

Should I be concerned??

- Graeme