[Samba] Which list for general help?

[Marian Mlcoch, Ing]

Your route table is bad...remove first route.
And missed local loopback if.

----- Original Message -----
From: "TheStar" <dogsdostink at ozemail.com.au>
To: <samba at lists.samba.org>
Sent: Tuesday, November 12, 2002 5:46 AM
Subject: [Samba] Which list for general help?


>
> Hello, I am having enormous difficulty in getting samba to work correctly
on the
> local network when the local network is on eth1.
>
> I have never had any trouble with samba when I used eth0...
>
> Here is my routing table...
>
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
> 255.255.255.255 *               255.255.255.255 UH    0      0        0
eth1
> 192.168.1.0     *               255.255.255.0   U     0      0        0
eth1
> 192.168.0.0     *               255.255.255.0   U     0      0        0
eth0
> default         192.168.0.1     0.0.0.0         UG    1      0        0
eth0
>
>
> This same computer works perfectly in every other area.  eth0 is dedicated
to the
> internet and masq's the network.
>
>
> findsmb can only see the local computer.
>
> I do not have an interfaces line in my smb.conf, and adding it apparently
makes little
> difference.
> eg,
> without the line, it apparently defaults to eth0
> With the line interfaces = eth1, the ip of the local computer changes, to
the ip that eth1
> uses, however, findsmb can still only see the local computer.
>
> The other computers on the network can't see this local...
>
> Any suggestions?
>
> I have recently subscribed, but since I haven't recieved any messages for
the past 24 hours, I do not know if I subscribed correctly, hence, could you
please 'cc' me?  I do not mind having several copies of a reply...
>
> Thanks in advance!
> --
> To unsubscribe from this list go to the following URL and read the
> instructions:  http://lists.samba.org/mailman/listinfo/samba