Does the command line "smbcontrol ALL reload-config" force a connected share to flush parameter ?

[Fengwei]

Hi all:
Thanks for your attention. I have a question about smbcontrol.
A user has read and write access to a share and already connected to the share,
then I delete the user from the write list in smb.conf and reload the config (use the command line "smbcontrol ALL reload-config"  ),
but it doesn't work, the user still has read and write access to the share.
Doesr the command line "smbcontrol ALL reload-config" force a connected share to flush parameter ?
The code comment in reload_services said set_current_service "this forces service parameters to be flushed", does this already been implemented?

thanks

________________________________
fengwei 11322 (RD)
-------------------------------------------------------------------------------------------------------------------------------------
本邮件及其附件含有杭州华三通信技术有限公司的保密信息，仅限于发送给上面地址中列出
的个人或群组。禁止任何其他人以任何形式使用（包括但不限于全部或部分地泄露、复制、
或散发）本邮件中的信息。如果您错收了本邮件，请您立即电话或邮件通知发件人并删除本
邮件！
This e-mail and its attachments contain confidential information from H3C, which is
intended only for the person or entity whose address is listed above. Any use of the
information contained herein in any way (including, but not limited to, total or partial
disclosure, reproduction, or dissemination) by persons other than the intended
recipient(s) is prohibited. If you receive this e-mail in error, please notify the sender
by phone or email immediately and delete it!