registry config not being updated on one of my clusters ... how do I troubleshoot this

[Volker Lendecke]

On Tue, Dec 09, 2014 at 12:35:34PM -0800, Richard Sharpe wrote:
> On Tue, Dec 9, 2014 at 11:46 AM, Michael Adam <obnox at samba.org> wrote:
> > Hi Richard,
> >
> > On 2014-12-09 at 11:21 -0800, Richard Sharpe wrote:
> >>
> >> I am trying to use registry-based configuration on two CTDB clusters.
> >>
> >> On one of then, the OCFS2 cluster everything works as expected. When I
> >> update a parameter on one node I can see it immediately on the other
> >> node by doing a 'net conf list' command.
> >>
> >> However, on the other cluster, even though ctdb status shows both
> >> nodes as up, nothing I do with net conf setparm on one node is visible
> >> on the other node.
> >>
> >> Where should I look to troubleshoot this?
> >
> > - samba compiled with cluster support?
> > - samba's config with "clustering = yes"
> > - ctdbd socket in samba matching ctdbd's socket?
> >
> > if that all is confirmed, it _should_ work.
> >
> > - ctdb status prints a lot of useful information
> > - (onnode all) ctdb getdbmap shows the db's attached on the
> >   current/all nodes.
> > - ctdb cattdb registry.tdb cats the local copy of registry tdb on
> >   a node
> 
> Curious.
> 
> When I do ctdb cattdb registry.tdb on both nodes, there is no
> difference, but node 1 shows nothing when I do net conf list.

Missing include=registry in smb.conf on one node?

Volker

-- 
SerNet GmbH, Bahnhofsallee 1b, 37081 Göttingen
phone: +49-551-370000-0, fax: +49-551-370000-9
AG Göttingen, HRB 2816, GF: Dr. Johannes Loxen
http://www.sernet.de, mailto:kontakt at sernet.de