Problem using v3.0 to NetApp servers

Jonny Larson jlarson at cips.nokia.com
Wed Jan 7 18:24:45 GMT 2004


Thanks for the info.

Another oddity is that the v3.0.0 smbclient works when run against a Netapp Filer 960 running Data Ontap 6.4R1, but fails (with NT_STATUS_LOGON_FAILURE) on Netapp version 6.4.2P6.

Again, any and all information/suggestions would be greatly appreciated.

Brett Funderburg wrote:

>I observed the *exact* same problem at a customer site not too long ago
>but using smbmount instead of smbclient. I saved a -d10 debug log of the
>output but never had a chance to look into it any further. The solution
>for now was to keep 2.2.x in place. I'd say this warrants further
>investigation but I'm not in situation to help out as I don't have regular
>access to a NetApp filer.
>
>brett
>
>  
>
>>Hello:
>>Using the v2.2.3a smbclient and a given userid/pwd, I can successfully
>>connect to and view a share on a NetApp server.  Using the v3.0.0
>>smbclient (same userid/pwd), I get the error:
>>
>>session setup failed: NT_STATUS_LOGON_FAILURE
>>
>>The debug output (-d 10) provided no clues as to what's failing.
>>
>>Has anyone had experience with this before?  Could someone shed some
>>light as to what may have changed between versions to allow this
>>failure?  More importantly, what can I do to correct this?
>>
>>I'd greatly appreciate any and all information anyone could provide.
>>
>>Jonny L.
>>
>>
>>    
>>
>
>
>  
>


More information about the samba-technical mailing list