solved: Problem using CP850 with samba-3.0.4

[Richard Sharpe]

On Wed, 4 Aug 2004, Alexander Bokovoy wrote:

> > I installed samba-3.0.4 with libiconv on Solaris 9.
> > Following is my installation for using Japanese(CP932).
> >
> > 1. Installed libiconv to /usr/local/lib
> >    # ./configure
> >    # LD_RUN_PATH=/usr/local/lib make
> >    # make install
> >
> > 2. Installed samba to /usr/local/samba
> >    # LD_RUN_PATH=/usr/local/lib ./configure --with-libiconv=/usr/local
> >    # LD_RUN_PATH=/usr/local/lib make
> >    # make install
> >
> > If LD_RUN_PATH was not set at the installation of samba,
> > the detection of libiconv failed.
> > Because the test program compiled by the configure
> > couldn't link the libiconv.
>
> I wonder if we would better document these details? It is certainly
> easiest way so close to release.

I agree that it might be easier to just document this for 3.0.6 and leave
the fix for 3.0.7. In that case, I might also get some time to look at it.

Regards
-----
Richard Sharpe, rsharpe[at]richardsharpe.com, rsharpe[at]samba.org,
sharpe[at]ethereal.com, http://www.richardsharpe.com