(no subject)

[Simo Sorce]

You have to recompile samba with ACL support, use the configure switch
--with-acl-support (be sure you have all needed dev libraries on your
system).

Simo.

On Thu, 2003-08-14 at 16:32, samit ghosh wrote:
> Hellow,
> 
> Presently I am in a project which is regarding transfering files/folders
> from windows side and then mapping the windows permissions of that file into
> corresponding Linux end with the help of access control list.
> 
> Now my problem is that when i add a user to a file in Linux end and set
> permissions to that user for that file with help of setfacl command the
> permissions are set properly for that new user. It can be seen with the
> command getfacl.Next when i want to see the permissions of the new user of
> the same file through samba it does show the new user name .Samba only shows
> the Owner and Group of the file with their permissions.
> 
> I want to see the newly added user and his permissions.How to get it??
> I will be grateful if i get some response regarding this.
> 
> Regards,
> Samit Ghosh
-- 
Simo Sorce - simo.sorce at xsec.it
Xsec s.r.l. - http://www.xsec.it
via Durando 10 Ed. G - 20158 - Milano
mobile: +39 329 328 7702
tel. +39 02 2399 7130 - fax: +39 02 700 442 399