[Q] Newbie PPP dial up problem
Donovan J. Edye
d.edye at bigfoot.com
Sun Oct 7 23:04:00 EST 2001
M,
I did that and it works (I am connecting to another private network hence
the no need for NAT). As I understand it I have enabled forwarding between
my interfaces ie ppp0 and eth0. Is that correct or have I missed the boat
again?
--D
-----Original Message-----
From: Martijn van Oosterhout [mailto:kleptog at svana.org]
Sent: Sunday, 7 October 2001 20:28
To: Donovan J. Edye
Cc: Linux List
Subject: Re: [Q] Newbie PPP dial up problem
On Sun, Oct 07, 2001 at 08:11:14PM +1000, Donovan J. Edye wrote:
> Shane,
>
> Thanks for the pointer, but the other problem I have is that I cannot seem
> to get traffic that is on eth0 to go out the ppp0 port. Not sure that NAT
> addresses that.
You did enable IP forwarding, right?
echo 1 > /proc/sys/net/ipv4/ip_forward
or something like that.
--
Martijn van Oosterhout <kleptog at svana.org>
http://svana.org/kleptog/
> Magnetism, electricity and motion are like a three-for-two special offer:
> if you have two of them, the third one comes free.
More information about the linux
mailing list