[Samba] CTBD public addresses and actual NICs being attached
lejeczek
peljasz at yahoo.co.uk
Thu Jan 26 16:38:54 UTC 2017
hi everyone
this - https://wiki.samba.org/index.php/CTDB_Setup - gives
out an impression that ".. These are the addresses that the
SMBD daemons will bind to.."
But - before I share software versions - it does not. My
smbd attaches to and listens on all interfaces: is this
normal, expected?
And if it is then how to tell/force smdb to bind to only
specific NICs?
I try usual:
bind interfaces only = yes
interfaces = 127.0.0.1 em1(which is the NIC used in
public_addresses)
I put there public IP(s) too, but to no avail, smbd would
not go to that public IP, daemon does not respond on that
IP(unless of course these directives are absent)... which,
seems loco to me.
How does one make samba run off only those public IPs?
many thanks,
L.
More information about the samba
mailing list