[Samba] Samba 3.2 on FreeBSD

[sgmayo at mail.bloomfield.k12.mo.us]

sgmayo at mail.bloomfield.k12.mo.us wrote:
>
> sgmayo at mail.bloomfield.k12.mo.us wrote:
>>
>> Herb Lewis wrote:
>>> run the following to find out where it should be
>>>
>>> smbd -b | grep CONFIGFILE
>>>
>>>
>>> sgmayo at mail.bloomfield.k12.mo.us wrote:
>>>> Ok, that is how I installed it, but the other answer from Terry was:
>>>>
>>>> "Yes in /usr/local/etc/smb.conf"
>>>>
>>>> The config file was in neither.  Most of the directories were in the
>>>> 'usr/local/samba' and there was nothing in the '/usr/local/etc' as far
>>>> as
>>>> samba goes.
>>>>
>>>> I would have thought that it would have put a smb.conf in one of the
>>>> directories or at least an example in one.  I just want to make sure
>>>> that
>>>> I get it in the correct place.
>>>>
>>>> Thanks.
>>
>> I tried that and it looks like the shared object libtalloc.so.1 is not
>> found.  I searched for it on the server just to make sure it was not in
>> the wrong place or did not have a link to it, but it is no where to be
>> found.  Guess I'll have to find out where to get it installed from.
>>
>> Any ideas on that?
>>
>> I may should have just left 3.0.30,1 on there and gone with that. :)
>
> Whoops my bad.  I had a typo.  Now I need to know for sure where the
> libtallco.so.1 goes.
>

I just uninstalled it and ran the configure again and I noticed a few
WARNINGS about sys/mount.h and netinet/ip.h present but cannot be
compiled.  I am not sure what that is about.  I think I'll just go back
and use the 3.0.30 port and install it.  Hopefully there is not too much
that I will be missing and maybe I can just upgrade to 3.2 later on.

Thanks.

-- 
Scott Mayo - System Administrator
Bloomfield Schools
PH: 573-568-5669  FA: 573-568-4565

Question: Because it reverses the logical flow of conversation.
Answer: Why is putting a reply at the top of the message frowned upon?